Note: No monitor-side configuration is required. Waveforms cannot be extracted over the Mini-D serial link; use the Analog/Sync port with an ADC instead.
| Cable | Adapter | Port | VR Device Name |
|---|---|---|---|
| 14-pin Mini-D ↔ DB-9F, custom (numeric) | None | X5 | Infinity |
| Analog/Sync cable → ADC (waveform) | None | X10 Analog/Sync port | — (ADC device) |
Dräger lists 5206441 as an export protocol cable and 4314618 as an analog output cable. Confirm compatibility and the cable termination for the installed configuration.
| Port | 14-pin Mini-D | → | DB-9F |
|---|---|---|---|
| X5 | 7 (GND) | → | 5 (GND) |
| X5 | 10 (TX) | → | 2 (RX) |
| X5 | 11 (RX) | → | 3 (TX) |
| Analog/Sync Pin | Connection in the ADC Example |
|---|---|
| 12 | Channel 1 (+) |
| 13 | Channel 1 (−) |
| 7 | Channel 2 (+) |
| 6 | Channel 2 (−) |
5206441).Waveforms are only available as analog voltages from the Analog/Sync port (Dräger part 4314618), read through an ADC (SNU-ADC, DataQ DI-149/DI-155, …).
Wire the ADC per Cable Pinout.
No monitor-side configuration is required.
Infinity and select the PC serial port used for the connection.