Deltex CardioQ

Deltex CardioQ

⚠️ Settings cannot be changed while the device is in use on a patient. Configure using DEMO mode before patient connection.

CableAdapterPortVR Device Name
Direct SerialNull Modem F/FMale serial portCardioQ

Connection Steps

  1. Attach a Null Modem (F/F) to the rear male serial port.
  2. Connect a direct serial cable to the PC via USB-Serial converter.
CardioQ — rear serial port

Device Configuration

  1. At boot, navigate to General → Patient Monitors → Monitor Setup.
  2. Select CardioQ Serial Protocol v2.
CardioQ Serial Protocol v2
  1. Verify Baud Rate = 57600 and Flow Control = No Flow Control → Finished.
Baud Rate and Flow Control confirmation
  1. Verify data transmission in DEMO mode before patient connection.