GE B40 / B20

GE B40 / B20

Note: This connection uses a custom 9-pin serial cable with pin 4 removed. Some monitor configurations require a GE Multi I/O adapter to provide the RS-232 connector.

CableAdapterPortVR Device Name
Custom 9-pin serial cable with pin 4 removedGE Multi I/O adapter if required; confirm the serial adapter for the cable used9-pin RS-232 connectorBx50

Connection Requirements

Connection Steps

  1. Connect the custom serial cable to the monitor's 9-pin RS-232 connector or the connector on its Multi I/O adapter.
Two rear-panel photographs side by side, captioned B40 back view and B20 back view; on each, a red circle marks the 9-pin D-type serial connector on the lower connector strip, beside the network jack and next to the AC power inlet

Device Configuration

No changes to the monitor settings are required for the connection described here.

Vital Recorder Setup