Deltex CardioQ / CardioQ-ODM+

Deltex CardioQ / CardioQ-ODM+

CableAdapterPortVR Device Name
direct serial cableNull Modem adapter (F/F)RS-232 serial portCardioQ

Connection Steps

  1. Connect a direct serial cable to the rear serial port using a null modem adapter (F/F).
CardioQ rear panel with the male DB-9 serial port circled, between the RJ-45 network port and the mains inlet

Device Configuration

Configure the monitor with no probe connected.

  1. On the start-up screen, select Monitor setup.
CardioQ start-up screen reading 'There is no probe connected', with Demo mode, Patients, Monitor setup, Instructions for use and Select user softkeys
  1. Select General.
Monitor setup functions screen showing the Time/Date, Reset all, Version data, Language, General, User settings, Users and Shift softkeys
  1. Select Patient monitors.
Monitor setup functions screen after pressing General, now showing the Hospital name and Patient monitors softkeys
  1. Select CardioQ Serial Protocol v2, confirm the settings below, and press Finished.
Patient Monitors list with CardioQ Serial Protocol v2 highlighted and Patient Monitor Settings showing Baud Rate 57600 and No Flow Control
ParameterValue
Baud Rate57600
Flow ControlNone

Vital Recorder Setup

Add the device as CardioQ and select the PC serial port used for the connection.