Input from analog signals #365
Kaspar Bachmann (2021-02-11 10:15)
· 701 view(s)
· 2 comment(s)
Dear Vital DB Team
Thank you for your great work.
We are thinking about implementing your software in our research facility. We have the following question:
How do you implement analog signals from third party devices (such as transonic flow meters) into vitalDB?
Thank you for your reply
vitaldb2017 (2021-02-23 23:28)
You need to prepare one of the analog to digital converters supported by our program.
The ADCs supported by the program are DataQ (DI-149, DI-155, DI-110, DI1120) and NI (USB-6008) products.
For cable connection method, refer to ADC connection method in DOCs/Hardware connection guide/Patient monitors.
Signal frequency and scale (gain) can be set when adding a device in the program.
The ADCs supported by the program are DataQ (DI-149, DI-155, DI-110, DI1120) and NI (USB-6008) products.
For cable connection method, refer to ADC connection method in DOCs/Hardware connection guide/Patient monitors.
Signal frequency and scale (gain) can be set when adding a device in the program.
DGMC Clinical Investigations Facility (2021-05-13 16:44)
Hello
Many thanks for your great software.
I am attempting to connect a Transonic Perivascular Flow Meter to Vital DB. I have purchased a DataQ DI-1100 ADC and made all of the connections to my laptop which uses Windows 7. With the Flow Meter in test mode, I receive a good signal using the WinDaQ software that comes with the ADC. However, when I attempt to add a device in VitalRecorder (v.1.8.15.15), nothing shows up in the COM port list. I have tried the instructions at the bottom of the add device page without success.
Do you have any suggestions?
Thank you!
Many thanks for your great software.
I am attempting to connect a Transonic Perivascular Flow Meter to Vital DB. I have purchased a DataQ DI-1100 ADC and made all of the connections to my laptop which uses Windows 7. With the Flow Meter in test mode, I receive a good signal using the WinDaQ software that comes with the ADC. However, when I attempt to add a device in VitalRecorder (v.1.8.15.15), nothing shows up in the COM port list. I have tried the instructions at the bottom of the add device page without success.
Do you have any suggestions?
Thank you!